3.1 WCU-4 update

General discussion
Post Reply
danielparmo
Posts: 3
Joined: Sat Sep 03, 2016 11:33 am

I just updated my handset to 3.1. The update promises additional radio channels. It is not the case for me, I tried it with my CForceMini RF. When updating, the update display announces 'Radio module update not needed'. My handset has serial #6149, and had the antenna update, from small to large done by ARRI London. Has there been newer updates since?

Best,
Daniel
Gernot Füllsack
Posts: 33
Joined: Tue Nov 24, 2015 8:05 am
Location: Vienna

Hello Daniel,

there are two different Radios with the big antenna.
On the back of the WCU-4 there is a sticker where you can check which Radio is in your unit.

If you have a sticker with "FCC ID: Y7N-EMIP100" you have the EMIP 2 inside.
If you have a sticker with "FCC ID: Y7N-EMIP300" you have the EMIP 3 inside.

The EMIP 2 cannot be updated.
Only with EMIP 3 it is possible to have the additional Radio channels.

for further informations please contact ARRI Service

Best regards
Gernot
Post Reply