Using Skylink with ETC Colorsource 20

Post Reply
AlanSteinheimer
Posts: 3
Joined: Tue Dec 04, 2018 7:54 pm

Hi - attempting to use Skylink as a transmitter with a ETC Colorsource 20 console. I’m not getting it to transmit even with a hardwire dmx line into the Skylink. Any thoughts to make this work?
Top
Silvan Liu
Posts: 38
Joined: Mon Nov 23, 2015 7:11 pm
Location: Burbank, California

Hi Alan,

The Skylink will by default expect a signal via IP (Wifi or LAN). If you wish to feed a DMX signal using the XLR port to the Skylink for transmission you will need to go into the browser interface (192.168.0.100) and under Port change the DMX source from Ethernet/WiFi to XLR
Silvan Liu
ARRI Service - Burbank, California
Top
Post Reply

Return to “Skylink”