Page 1 of 1
Wcu-4 end stops
Posted: Wed Feb 21, 2018 7:46 pm
by jakecamera
Is there a way to soften the finding of the end stops when using auto calibration w cforce mini motors? I know I can turn down the overall torque ( I leave it at 3) but then I'd have to change it back every time since it makes long pulls too slow at 1 or 2. I'm using some delicate lenses and I think the finding of the ends is stressing them too much
Any solution? Don't some focus units have this feature?
Re: Wcu-4 end stops
Posted: Thu Feb 22, 2018 11:55 am
by Gernot Füllsack
Hello,
no, the only way is to set down the torque for the calibration and after that change it back.
best regards
Gernot
Re: Wcu-4 end stops
Posted: Fri Jun 01, 2018 5:51 am
by jakecamera
Is there not some way that could be automated so that it automatically sets the motor torque to 2 then changes it back? I mean, I can do it by pressing the buttons in a certain sequence, so why can't that be programmed to a one push solution? Possible or not? Many would like this feature. Have talked with several people who have had damaged lenses b/c torque was too high when calibrating. Especially in this day and age of using vintage/delicate lenses.
Every ac would welcome this feature.