Page 1 of 1
Using Skylink with ETC Colorsource 20
Posted: Sat Dec 15, 2018 1:02 am
by AlanSteinheimer
Hi - attempting to use Skylink as a transmitter with a ETC Colorsource 20 console. I’m not getting it to transmit even with a hardwire dmx line into the Skylink. Any thoughts to make this work?
Re: Using Skylink with ETC Colorsource 20
Posted: Mon Dec 17, 2018 7:50 am
by Silvan Liu
Hi Alan,
The Skylink will by default expect a signal via IP (Wifi or LAN). If you wish to feed a DMX signal using the XLR port to the Skylink for transmission you will need to go into the browser interface (192.168.0.100) and under Port change the DMX source from Ethernet/WiFi to XLR